t50 counter shaft circlip + smallport spark plug lead

[PULSE]

Hey guys, I'm now currently after a smallport number 1 spark plug lead, and the circlip from the counter shaft of an ae86 spec t50 gearbox. In this pic its the circlip thats missing from around the smaller shaft bearing (the one with the bolt head on top of it). It sits flat to the gearbox surface. It has to be from an Ae86 spec t50.

http://i289.photobucket.com/albums/ll217/mgrazotis/P1010001-1.jpg


I'm located in lilydale and I'm willing to drive to pickup parts otherwise I'm happy to pay postage.

Cheers, Matt

[PULSE]

BUMP

[skin]

I have a extreme lightened flywheel 3.9 kg used twice in mint condition



I also have the right rear water outlet for a 4age for a rwd conversion


I'd post to your door $550 for both

[PULSE]

Hey mate, thanks for the offer but I definitely don't have that kind of money to throw around, I'm looking for the cheapest possible to get me on the road. I've got a RWD water housing lined up but if it falls through I'll contact you about that. Also, I'm now after a 200mm flywheel instead of a 212mm one because I have found a clutch to suit the 200mm.

Cheers, matt

[RobertoX]

i got a stock one here $75

cheers

[Roo]

^^ got one here can have it for 60 :P

[wth03]

i have one here for $50 out from my jdm box
in melbourne, templestowe
i can get it stepped for u for extra cost

[PULSE]

replied to the last guy, decent price and near me is better than more expensive price + shipping from other states :P Still chasing a RWD water housing.

[duste]

i have standard one with stock clutch $50

[PULSE]

Sounds good, the other guy hasn't gotten back to me yet so in the meantime, how much would postage to to VIC, lilydale 3140 be? Also, I still need the RWD water housing and I also need the RWD sandwhich plate that goes between the gearbox + engine.

Cheers, Matt

[PULSE]

BUMP - still need a RWD rear water housing.

[Golberg]

<div class='quotetop'>QUOTE (PULSE @ Jun 20 2008, 04:24 PM) <{POST_SNAPBACK}> (index.php?act=findpost&pid=549427)</div>
BUMP - still need a RWD rear water housing.[/b]
I've been mucking around with trying to put a RWD water rear outlet onto my small port, no go. The little outlet pipe for the TB sits EXACTLY where the head oil drain hose sits so its just not going to work. Best bet is the AE82 one, I've attached a little bit to my AE82 outlet so that its very similar to the RWD except the little TB outlet doesn't interfere with that hose. As said before, I've got a spare AE82 one if you want it.

[PULSE]

So an AE82 one can be modified to have the TB outlet then? Just need to drill a hole in the pipe and then weld on an outlet? If thats the case, how much did you want for your AE82 one?

[PULSE]

Ok I'm after a couple new things, mainly after a set of flywheel bolts and the lower section of a RWD cast manifold.

Cheers, Matt