1: the bushes should be the same but to be sure order xt130 ones
2: no
3: -
4: no
easy eh?
i'm sure most of this has been covered through the thread but not in an entirely direct manner.
i will be using Power Steering arms, lock spacer and XT130 LCA's on an AE86 Strut.
heres my questions, inb4 flaming for noobness or not reading thread properly rabble rabble.
1. i know i need to cut off the lock stops but when i rebush/joint the LCA do i use Xt130 ones or AE86 ones?
2. will it be necessary to run different rack ends or tie rod tubes/ends?
3. if so do i just want the tie rod ends or tie rod ends + tubes?
4. will any of this change when i coil over the strut with Camber Tops and RCA's?
Last edited by Chaos Theory; 11th October 2009 at 03:41 AM.
1: the bushes should be the same but to be sure order xt130 ones
2: no
3: -
4: no
easy eh?
My website: SQ Engineering - 4AGE and 3SGE upgrade/replacement parts
- SQ Engineering on facebook -
Please e-mail to contact me instead of sending a private message on here.
went to u pull it today and got my self some XT130 LCA's, was too lazy to unbolt everything so got the steering arms and tie rod ends at the same time.
best $36 i ever spent.
someone should make a guide on fitting them with all different combinations lol and refurbishing the LCA's
Trial and error works! lol
refurbishing them is as easy a getting the grinder out and a black pressure pac!!
Chop off lock stoppers,clean and paint! of course you could go all out and powder coat em?
Bushes and ball joints need to be pressed in at a shop that can do so..
Josh
-----------------Independent--------------------
43ger
Performance
SINCE 2008
if anyone knows the length of mx83 lcas that would be awesome!!
+1 on mx83 arms... thinking i want 10-20mm per side more track
GJ sigma LCA's and ae86 LCA's
edit*
Q: anybody know the length of GJ sigma LCA's? or are they the same as GE sigma LCA's?
A: measured the GJ sigma LCA's and they're about 340mm-350mm. To fit these i have had to get the balljoints machined to fit the powersteering arms and have had to get ae86 bushes(60mm) replacing the 65/66mm GJ sigma bushes
hmmm, running these would probly give about 5 degree neg camber with no cambertops... and probly 3 degree negative!? as the minimum with cambertops.
will post what i end up with.
Last edited by hachi_dk; 7th November 2009 at 08:45 PM.
anybody ran GJ sigma arms before? pro's? cons? opinions?
also, anybody know, if i use johnny's extra lock tie rod ends with stock ae86 rack ends, will there be enough adjustment to get them to reach or will i have to upgrade to something? not too sure about rack ends so somebody let me know.
Fil.
Last edited by hachi_dk; 8th November 2009 at 12:00 AM.
i sense geometry failure with sigma arms + some.
don't be cheap and use camber tops (+xt130 arms) is a winner.