have you checked if it fits yet? I ran an S15 gearknob on my sprinter with zero problems.
OH HAI.
So, I've got a gearknob. It is Toyota thread. This is all very well and good, but I have a dirty Nissan now.
I've tried looking for thread converters at repco, autobarn, and supercheap, all to find they have nothing.
So, where the hell do I get them?
Thanks,
Ryan.
have you checked if it fits yet? I ran an S15 gearknob on my sprinter with zero problems.
ok, you could get a bolt that fits the gearbkob and get a hole drilled and tapped to suit the nissan stick, or get a sleeve turned to fit between i suppose.
make a convertor? male one end(toyota) female other end (nissan)
one of my friends used some hoes on the shifter and just screwed the knob over it
you play halo?
add me GT: samnbhnc
Toyota is M12 x 1.25 fine, R31 is M10 x 1.25 fine.
I would honestly sell your current one and go buy a gearknob to suit the R31.
Member of the Cable-Tie Cartel.