Places to send you car

[Sprinterboy]

Ok fellas, (and ladies if we have any on board)

List up the places you've work done on your spoonta and would happily send others. Try to refrain from bad mouthing bad workmanship if you weren't happy. Not here to make enemies

Good example: "AutoPlaceofawesomeworkshop" was great; bob and Barry have a lot of great knowledge and always willing to make time

Or Garage Bla bla, not so great IMO wasn't happy with service/price.

Me first

Autotech/Aflatech Hume (just moved from Fysh)
Provide great service, Great Advice, bit $$$. But worth it.
Services: Everything from wiring your dash to Dyno tuning and rebuilding engines. Autronic/Haltech/Motec resellers

Carco Exhaust Centre Belconnen
Russel is an ex 86 owner, has plenty of race exp.
Services: Exhaust, custom fab work. Wiring, Autronic reseller

Jakes performance: Wasn’t happy with Service provided. (I think he’s closed down now anyway)

[maxhag]

For Exhaust, I have always gone to Glenn @ Roadway Exhausts, Belconnen. Good work, Very cheap prices +REP

I once went to 'The Exhaust Shop' in mitchell, to weld a crack in my dump pipe and re-sit the exhaust,
It cracked again a week later and they wouldn't come to the party.... neg REP

For Tuning/Dyno, I went to Kit @ Gentech in Mitchell. He knows his drag stuff....
I reckon he did a good job, but I have nothing to compare it to. It cost $800

I used M&A Engeernig for my custom g/box mount and custom tailshaft. Did a top quality job, used all NEW parts, but cost $1050. +REP

For Smash Repairs, I use Braddon Smash Repairs. Did a great job, and was a good price.

[Sprinterboy]

+ for M&A, steve used them to also mount up his W57, cost a bit but worth it IMO.

[maxhag]

yeah, Mick (M&A) knows his stuff...

[maxhag]

Can anyone recomend someone for a New intercooler, fitting and custom piping?

Best ad in phonebook seems to be Phillip radiator centre. Any reports?

Who did yours Justin?

[jamekins]

I need to get an axle straightened. I hear southern diff is good for this. Is there any where else I should be checking out too? and how much would I have to part with?

[maxhag]

Try M&A engineering in Mitchell......

[jamekins]

Gunna bump this up again to check if braddon smash repairs is still a good place to look at for some panel beating/chassis straightening? Got rear ended today (great Christmas present) and the back end of the car is pretty munted. Also anyone got a fuel tank and some tail lights kicking around they may be willing to part with?

[maxhag]

Can you put up a pic, so we can see how bad the damage is?

[jamekins]

For those that're interested