Velocity Stacks / Trumpets and Intake Adapter Plates

[Rice86]

do you keep these in stock?
is postage included with the prices shown?
can you make custom lengths and what is the turn around time?

[Sam-Q]

Right now I have 20, 43, 70 and 110mm in stock for silvertop.

Pending on the payment method I can mail them on the same day usualy. For custom turn around time in only a few days but there is an additional cost, with these you get to choose your length and bellmouth size.

Post is extra but it's pretty cheap.

[Rice86]

sweet i'll take some measurements and let you know my requirements and go from there

Thanks Sam

[Sam-Q]

no problem, also keep in mind I can get large bellmouths rolled and then machine the sides to either clear each other or that and enough room for slide on filters. I charge $5 per side for the service so for 4 cylinders it's +$30.

Here is a picture of some B/T 150mm stacks I put together:

[Rice86]

holy snap that looks the good

Sam i think i'll just go with your 110mm to suit silvertop.. my setup is 16v with T3 adopter and silvertop ITB.. i measured and i think 110mm SHOULD be ok or really close to hitting something, but shouldnt touch i think.. your thoughts? do you know if these will hit at all with similar setup? my setup is not in the engine bay so i could only measure total length and with assumption guessed where the bell mouth might end up.

[Sam-Q]

I have seen 70mm fitted with a T3 adapter and it came really close, so no not a hope unless your not running a booster.

[ke_70]

made any to suit r1 carbs?

[Sam-Q]

no but I would be most interested in giving it a go, if I can make them and sell them I would give a serious discount to the first person who gave me the samples I need

[ke_70]

mine are o the way from the us ATM
i'd be happy to help out when the get here.

[Sam-Q]

unbolting a throttle is too much of a mess around? got a pic or link of the ones your getting?