Yeah cheers, it was a prick of a job. But atleast now I have learnt a few things before spraying the rest of the car, I'll use a gun for that
Engine updates
Polished valves with 3 angle valve grind in head
Ported and polished inlet ports
Same deal on the exhaust ports, more polish on the exhaust ports to exitthe gasses faster.
Also port matched the inlet manifold and extractors also shaved the gaskets so there will be no resistance.
Ordered some 7mgte injectors to keep up with all the extra air flow.
Can't wait to drive this shit.
looks rad man, theres to much hardparking going on, lol
~KEEP DRIFTING FUN~
I am a dedicated garage glory whore.
lol, but needs more skids, good luck with it man
~KEEP DRIFTING FUN~
good job man! cant wait to slide with you.
wow amazing work
thanks lads, I really must big up my engine builder, Marky, perfectionist isnt enough of a word to describe this guy.
Robo: Im so keen to go sliding with you guys again, every fucking morning sesh I get to see pics of you and Nick pulling stupid angles and having a ball, Im over this building shit.
So shits been going slow, spent almost a month in Thailand and bought a house so that shifts priorities a bit, but in saying that I've bought an sc14 and will be picking up a w58 box setup shortly as well so I'm still sinking a few shauns into this bitch. Really over waiting for this motor but the dude is doing me a massive favour so I cant complain.
Here's how the motor is looking now
It's pretty much done, just waiting for some stainless nuts to complete the shine fest marky's got going on.
Last edited by ae86 slide; 31st January 2011 at 09:14 AM.
Specs on engine build are:
Grind crank
Hone cylinder bores
Deck block
Shave head
Overhaul oil pump
New water pump (all new O-rings throughout)
ARP rings
ACL bearings (main and conrod)
ARP head studs
Thrust washers
Stainless steel welsh plugs
7mgte injectors
N/A Bigport cams (slightly more lift and duration)
Cometic 1mm head gasket
Full head porting and port matching to inlet and exhaust manifold (40 hours spent)
Reset valve clearances
Replace all gaskets and seals throughout motor
Machine flywheel (ae101, 212mm)
New Exedy HD cluth
Gates timing belt and tensioner
Picked up my SC14 today off Johl (thanks mate) and W box setup should be on the scene next month, Im building enthusiasm again!!
Last edited by ae86 slide; 5th February 2011 at 05:55 PM.
Posting Permissions
Reply With Quote
